PlasmaGLO™ LED Mask

Step 1

Light Sensitivity Test

Follow these instructions to check if you are light sensitive. First, supply power to the device (see instructions in manual). Then, place your mask over your inner arm, making sure the light is shining onto the skin and wear for 10 min. Wait for 24 hours. If you experience pain or discomfort, or redness that lasts for more than 2 hours you might be light sensitive. Please consult a doctor for advise.

Step 2

Cleanse Your Skin

Before starting the treatment, thoroughly cleanse your skin, remove any cosmetics that contain a chemical or acidic element that may affect light output, and lead to a decreased or in-effective treatment.

Step 3

Connect and Wear the Mask

Use the Velcro Straps and insert the straps into the apertures on both sides of the mask to ensure that they can be fixed on the mask. Connect the mask to the controller with the USB-cable provided. Put the mask on your face. Adjust the straps to ensure that the mask fits well to your face / desired position.

Step 4

Start a Treatment

Turn on the mask by pressing the controller’s power button and holding down until it turns on. The battery indicators will light up to indicate the device is turned on. The device will automatically turn off when the treatment time (10 minutes) is over. You can turn off the device at any time by pressing and holding the power button.

Take Off the Mask / Clean It

Take the mask off your face and clean it (see instructions in the How to Use section).